Has anyone cut masts down before? I have 2x 460 masts and I could do with a 430, and I've seen some mention of cutting them shorter.
Is it better to cut from the top or the bottom of the mast?
Or, if anyone wants to swap a 460 for a 430 I'd be happy to do that!
how much would you like to remove?
to try and maintain the masts bend characteristics, you could take a bit off the top and bottom
if you take too much from the bottom you risk not fitting the mast base/extension properly, and too much from top might stiffen the feel of some masts
I have taken a 460 to a 430 with all of it off the bottom. It made a difference with rigging and general handling but so slight it was preferable to buying a new mast.
I have cut down a couple of older sdm np masts and they seem to work ok, both are old c30 s one went from 460 to 430 with all cut from bottom, I use this on on a np 4.5 wave sail (older sail not sure what year but it has on it 10 year anniversary dunkerbeck limited edition) the other I cut about 10 cm off the bottom because it was split and have been using this on an aerotech 5.8 wave sail circa 2006, only problem its a bit stiff on bottom as bottom batten doesn't always rotate properly have to give it a gentle kick sometimes when coming out of a jybe.
