Hey all,
I've recently purchased a 145l JP funster. Its been great so far, however I now want to move the footstraps further back and therein lies my problem. The screws were unbelievably difficult to get out, and now I can't put them back in! They'll screw in until they wont go any tighter, but the pad on the end of the footstrap still swivels from side to side. The only thing I can think of to tighten them more is used a drill, but then it'll probably strip the screws! Has anyone else experienced this??!!
mabey try a few diferent screws .. but make sure the tread runs at same angle as old screw .. just a smaler gague
Use some washing up liquid to lub the screw, and use a large size screwdriver to get decent torgue on the screw. Makes a huge difference! I had this problem with a new board, when I just used a little phillips screwdriver and no lubrication :-)
