Forums > Sailing General

Soliloque works

Reply
Created by Roama > 9 months ago, 10 Apr 2014
Roama
TAS, 195 posts
10 Apr 2014 8:09AM
Thumbs Up

Slipped stripped and re dipped!





Ramona
NSW, 7723 posts
10 Apr 2014 8:49AM
Thumbs Up

Very nice. I like the real transducer mounts.

cisco
QLD, 12361 posts
10 Apr 2014 10:27AM
Thumbs Up

Beautiful. There is a huge satisfaction in restoring timber yachts. You don't see too many of them here in Qld as the toredo worms in our warmer waters are voracious.

Roama
TAS, 195 posts
10 Apr 2014 11:34AM
Thumbs Up

' Soliloque of Searle ' was built for Jeffery Hyland Penfolod of Penfolds wines with no expenses spared in 1960, we have only owned her for 3 months an undertaken a major restoration to bring back to her former glory which she is just deserved. It is an absolute pleasure and I am loving every minute of it !! She was in a pretty sad state when we bought her. It is a privilege to own a crafted piece of history!

MattM14
NSW, 190 posts
10 Apr 2014 1:49PM
Thumbs Up

That's a lovely restoration job.

+1 for keeping the old girls looking smart. Still glad that wasn't my elbow grease that got her to that lovely finish

Some more pics when she is back in the water would be great.

Roama
TAS, 195 posts
10 Apr 2014 4:11PM
Thumbs Up

Currently repairing cockpit combing reglazing and stripping all bright work back to teak, stripping booms back, new sail bags and lazy jacks and giving sails the once over







CoolRunnings
NSW, 159 posts
10 Apr 2014 10:32PM
Thumbs Up

I don't know much about Jefferey, but Thomas Hyland has given me a few headaches in the past!

Seriously though, this yacht looks like it is in the right hands now.

Judging by the close up pics shown of the cabin, the grain and quality of the timber is just superb.

The deck planking is also in great condition and not looking 'boney' like the majority tend to.
By that, I mean most people will take the easy way and scrub with the line of the planks.
Big mistake and going across the grain will reduce a lot of wear or waste material removed.

What are the timbers used on the hull planking?

Congrats C.R.

HG02
VIC, 5814 posts
11 Apr 2014 5:42AM
Thumbs Up

she can mind my mooring any time, such a lovely old yacht.

Roama
TAS, 195 posts
11 Apr 2014 1:53PM
Thumbs Up

She is 42ft of jarrah and 16tonne ,





CoolRunnings
NSW, 159 posts
11 Apr 2014 7:20PM
Thumbs Up

Parkster-Was the rudder removed to check on its condition or was there a problem.

You probably would have needed a crane just to lift it out!

Roama
TAS, 195 posts
12 Apr 2014 10:45PM
Thumbs Up

She has a PRM hydraulic box which we had to replace rear seal in, slid shaft out to find electrolysis at gland packing point caused by no earth link from engine over coupling to prop end of shaft. Replaced cutlass bearing and machined new bearing on keel for rudder post and yes rudder is bloody heavy two man job!!



Subscribe
Reply

Forums > Sailing General


"Soliloque works" started by Roama