Forums > Sailing General

Pickling paste

Reply
Created by Propwalk > 9 months ago, 23 Jan 2018
Propwalk
91 posts
23 Jan 2018 3:16PM
Thumbs Up

Hi all,
looking at the ss rigging on my Cav 32 I see some surface "rust" which I want to clean up, just wondering if "Autosol Metal Life Saver" at Bunnings is similar to the pickling paste used by welders?

Bill

Jode5
QLD, 853 posts
23 Jan 2018 5:36PM
Thumbs Up

I find Ronstan Gelcoat Restorer as good as anything. Just make sure you don't get it on any aluminium.

FelixdeCat
NSW, 234 posts
30 Jan 2018 12:54PM
Thumbs Up

I doubt bunnings will sell anything as strong as pickling paste. You can get the paste from any BOC store but just be very careful handling and storing it. The label on the front does say "Inhalation will cause death"

LooseChange
NSW, 2140 posts
30 Jan 2018 7:18PM
Thumbs Up

Select to expand quote
FelixdeCat said..
The label on the front does say "Inhalation will cause death"


And they mean it, that stuff is so toxic I'm surprised you can buy it over the counter without a prescription .... or something.
It's a combination of hydrofluoric acid and nitric acid. I would advise that you not use it, or if you do, then have an assistant in case the fertiliser goes into the ventilator .

2bish
TAS, 823 posts
30 Jan 2018 10:30PM
Thumbs Up

I used this stuff recently to clean rust off stanchions and lower rigging. Surprisingly quick acting and effective. Use a small fine stiff brush to get into the cracks and cranny as you apply.
www.whitworths.com.au/starbrite-rust-stain-remover-spray-650ml

Ramona
NSW, 7740 posts
31 Jan 2018 8:27AM
Thumbs Up

Select to expand quote
Propwalk said..
Hi all,
looking at the ss rigging on my Cav 32 I see some surface "rust" which I want to clean up, just wondering if "Autosol Metal Life Saver" at Bunnings is similar to the pickling paste used by welders?

Bill


Metal Gleam is the answer. I used to buy this stuff in 20 litre containers. Mix with water in the recommended ratios and slop it on. Agitate with a brush or sponge, leave for a few minutes and hose off. Use over all your stainless steel and fibreglass and painted surfaces just like you would do with oxalic acid. Leaves SS shiny and rips off stains on fibreglass. Cleans and softens paint temporarily prior to over coating. Used widely in the fishing industry. Also good on bare aluminum dinghies etc where it will etch the alloy. Reasonably safe just don't splash in to your eyes!
www.nowchem.com.au/wp-content/uploads/2016/12/Metal-Gleam.pdf

Like oxalic acid it works better on a warm day. Try to use it away from nosy pensioners, there will be some foam going into the water.

Propwalk
91 posts
31 Jan 2018 6:27AM
Thumbs Up

I was informed by Bunnings that it is a special order and must be picked in person (no post) it is pickling paste but a modified formula.

Bill

Jolene
WA, 1622 posts
31 Jan 2018 7:11AM
Thumbs Up

You really need to differentiate between pickling/ pacifying and cleaning.
For cleaning stainless components I use a product called Spotless Stainless.

http://www.mysailing.com.au/news/spotless-makes-stainless-steel-sparkle.

For pickling welds I am trying my own concoction of a citric acid in a electrolysis bath to stay away from using the paste that I always seem to get on my clothes, in my eyes etc.
Citric acid can be bought in de scaling products for cleaning commercial kitchen equipment.

www.domchem.com/PDF/com/Descaler%20SDS.pdf.

I'm also going to give it a go for cleaning stainless and descaling the raw water cooling circuit of the engine.

2bish
TAS, 823 posts
31 Jan 2018 9:30PM
Thumbs Up

Jolene said..
You really need to differentiate between pickling/ pacifying and cleaning.
For cleaning stainless components I use a product called Spotless Stainless.

http://www.mysailing.com.au/news/spotless-makes-stainless-steel-sparkle.

For pickling welds I am trying my own concoction of a citric acid in a electrolysis bath to stay away from using the paste that I always seem to get on my clothes, in my eyes etc.
Citric acid can be bought in de scaling products for cleaning commercial kitchen equipment.

www.domchem.com/PDF/com/Descaler%20SDS.pdf.

I'm also going to give it a go for cleaning stainless and descaling the raw water cooling circuit of the engine.


Spotless sounds good, where did you buy that?

Ramona
NSW, 7740 posts
1 Feb 2018 7:55AM
Thumbs Up

Check where these products are made. Metal Gleam is made by Nowra Chemicals. They make stuff for other major brands which sell with a different label and boutique prices.

Jolene
WA, 1622 posts
1 Feb 2018 4:57AM
Thumbs Up

2bish said..

Jolene said..
You really need to differentiate between pickling/ pacifying and cleaning.
For cleaning stainless components I use a product called Spotless Stainless.

http://www.mysailing.com.au/news/spotless-makes-stainless-steel-sparkle.

For pickling welds I am trying my own concoction of a citric acid in a electrolysis bath to stay away from using the paste that I always seem to get on my clothes, in my eyes etc.
Citric acid can be bought in de scaling products for cleaning commercial kitchen equipment.

www.domchem.com/PDF/com/Descaler%20SDS.pdf.

I'm also going to give it a go for cleaning stainless and descaling the raw water cooling circuit of the engine.



Spotless sounds good, where did you buy that?


I saw an add in the Cruising Helmsman mag and bought it online. Can't remember the online store exactly but it might have been this one

spotlessstainless.com/

These sort of products are no magic wand on heavily corroded items, but on tea stained and light rust spots it works great and consumes little time to achieve a great result and maintain. You seem to notice the brightness change in the stainless a couple of hours after you hose the stuff off.



Subscribe
Reply

Forums > Sailing General


"Pickling paste" started by Propwalk