Forums > Kitesurfing General

To role or to fold that is teh question.

Reply
Created by Plummet > 9 months ago, 1 Dec 2013
Plummet
4862 posts
1 Dec 2013 4:51AM
Thumbs Up

Well? do you role or fold your kites up!

I'm a folder. I see a lot of guys rolling tight bundles and I think why?

Slashrockson
NSW, 126 posts
1 Dec 2013 8:10AM
Thumbs Up

I fold in half wing tip to wing tip, then slat starting from wing tips. cuts the time and effort when you're knackered after a big session, still lets residual air out as you fold.

Gorgo
VIC, 5101 posts
1 Dec 2013 8:48AM
Thumbs Up

There's no real difference in the end result. If you roll then pat it flat you end up with a fold.

I fold the dacron tips to get a neat starting point for the leading edge and a firm section to roll around, roll that along the leading edge, then pat flat at the middle.

Rails
QLD, 1371 posts
1 Dec 2013 9:14AM
Thumbs Up

Sam

Select to expand quote
Slashrockson said..

I fold in half wing tip to wing tip, then slat starting from wing tips. cuts the time and effort when you're knackered after a big session, still lets residual air out as you fold.


e

harry potter
VIC, 2777 posts
1 Dec 2013 10:18AM
Thumbs Up

I fold then roll then fold.... and sometimes a bit of stuffing at the end

Puetz
NT, 2186 posts
1 Dec 2013 9:10AM
Thumbs Up

... roll, fold in thirds then stuff into bag.

winwil
VIC, 80 posts
1 Dec 2013 10:56AM
Thumbs Up

I have taken this a portion guy's advice and convinced myself this method preserves the bladder and material better. I do a slack version of it. It kind of becomes more folded than rolled but quite loose and is very quick. I switch between what he calls the 'taco' method and the two roll method.

By mixing it up I reckon you don't have folds in the same spot every time preventing excessive wear at the folds.


SaveTheWhales
WA, 1897 posts
1 Dec 2013 8:19AM
Thumbs Up

The fold in half and roll is my preference. Stops a bit of pissin about and if your bag is big enough, once inside - puff it up like a bed pillow to reduce pressure on it also...

puffy
89 posts
1 Dec 2013 9:21AM
Thumbs Up

I roll it, I fold it
I roll it again
Layer upon layer upon layer

Kamikuza
QLD, 6493 posts
1 Dec 2013 2:43PM
Thumbs Up

There's a guy here who just grabs it all in a big pile and carries the kite across the road to the clubhouse and dumps it in a corner of the store room. All three of his Switchblades are just a big pile on the floor

I do like the video says... but I came up with that on my own

Just be careful pushing the kite down to get the air out - I've poked holes in the canopy when the zip tab was sticking up...

gruezi
WA, 3464 posts
1 Dec 2013 1:56PM
Thumbs Up

Fold and keep it loose.

mick14
SA, 343 posts
1 Dec 2013 4:31PM
Thumbs Up

Advice I was given that applies to both buggy and surfing kites, is to get a larger bag so you don't have to fold the kite any smaller than necessary to pack up. Better for the fabric not to be folded too tightly or repeatedly along the same line.

puppetonastring
WA, 3619 posts
1 Dec 2013 2:27PM
Thumbs Up

Select to expand quote
Slashrockson said..

I fold in half wing tip to wing tip, then slat starting from wing tips. cuts the time and effort when you're knackered after a big session, still lets residual air out as you fold.


YEAH - another devotee of total sense.
(and hes not even from our school!!)
This really is a no-brainer.
- keeps sand on the outside of the canopy rather than the inside where it can grind away at strut lines etc
- saves that hassle of the 1st roll unrolling as you deflate & roll the 2nd side
- but besides those minor things it is twice as quick.
Hold the wing tips > flick in the wind clears excess water & sand & lays the two halves downwind ready for a neat quick roll.

Beats me how the wing tip to centre ever came to be ?????
Watch the vid - its obvious.

Kamikuza
QLD, 6493 posts
1 Dec 2013 8:35PM
Thumbs Up

Tip-to-tip doesn't really work with delta or bow kites, especially when the wind is up... non-square tips and long curved profiles to the center tend to flap in the breeze and make a mess.

I usually kick sand onto the kite as I'm rolling it up anyway

Loose folds don't unroll as you do the other side, unlike a proper roll...

Then there was that guy who could fold and pack a kite in under 10 seconds... can't find the video now of course.

Subculture
443 posts
1 Dec 2013 8:15PM
Thumbs Up

Select to expand quote
Kamikuza said...

Then there was that guy who could fold and pack a kite in under 10 seconds... can't find the video now of course.



Oh here you go then

The Vimeo version is clearer than YouTube.

Years ago now but still worth watching..

cauncy
WA, 8407 posts
1 Dec 2013 8:32PM
Thumbs Up

scrunch, if you can fold or roll your kite on the beach then it aint windy enough

Kamikuza
QLD, 6493 posts
1 Dec 2013 10:38PM
Thumbs Up

Good job SubCulture!

Ok less than 30 seconds then!

psychojoe
WA, 2232 posts
1 Dec 2013 10:36PM
Thumbs Up

Select to expand quote
puppetonastring said..

Slashrockson said..

I fold in half wing tip to wing tip, then slat starting from wing tips. cuts the time and effort when you're knackered after a big #, still lets residual air out as you fold.


YEAH - another devotee of total sense.
(and hes not even from our school!!)
This really is a no-brainer.
- keeps sand on the outside of the canopy rather than the inside where it can grind away at strut lines etc
- saves that hassle of the 1st roll unrolling as you deflate & roll the 2nd side
- but besides those minor things it is # as quick.
Hold the wing tips > flick in the wind clears excess water & sand & lays the two halves downwind ready for a neat quick roll.

Beats me how the wing tip to centre ever came to be ?????
# the vid - its obvious.


pure genius
I'll be trying this tomorrow



Subscribe
Reply

Forums > Kitesurfing General


"To role or to fold that is teh question." started by Plummet