Forums > Kitesurfing General

About to fix my first board help needed

Reply
Created by DaylightDebt > 9 months ago, 17 Mar 2015
DaylightDebt
WA, 296 posts
17 Mar 2015 2:28PM
Thumbs Up

Scored for a north wam that comes with a bit of damage, looking to fix it up as a spare. Keen to do it myself as a learning experience and would like to tap into the wealth of knowledge that lives on sb.

Please see pics. I have a tube of solarez and lots of eagerness to give it a crack. The board has been left to dry for about 4 weeks.









COL
NSW, 554 posts
18 Mar 2015 5:21PM
Thumbs Up

dig out or sand off any delaminated bits. Sand back the paint from the area. Confine the repair to no more than is needed. ideally sand both sides of the fractured glass to feathered edges. Absolutely DON'T use any sort of Polyester resin. Epoxy resin only. Fill any holes with resin & Q-Cell mix to toothpaste consistency. Allow to set, then sand back again if required to an even surface. Tape up around repair so you don't mess up more area than you need to. I'd lay 2 layers of 6oz over this, the 1st layer a bit smaller to fair the repair better. Around the rail I often attach masking tape to the edges of 2 sides of the cloth so you can lay down the cloth fixed into position, with a bit of tension across it. After wetting out the cloth with epoxy resin firmly squeegy off what you can. Use an old credit card. The cloth is the strength not the resin. Let set, sand off any dags and down through the tape at the edges, and lightly squeegy a layer of resin only, or resin/Q-cell to fair off.
Col

DaylightDebt
WA, 296 posts
18 Mar 2015 3:32PM
Thumbs Up

Cheers col, where the best place to get the cloth, resin and qcel, boat shop? Dumb question I know but never had to buy this stuff before

WA Surf Mandurah
WA, 13 posts
18 Mar 2015 4:01PM
Thumbs Up

www.fibreglass-resin-sales.com.au/

111 Kew St Welshpool
9470 2571

Go and see these guys.

They are really helpful and know their stuff. If you are nice to them you can take your board in there and they will give you good trustworthy advice on how to best fix it and they will have everything you could possibly need to get the job done. everything in one stop.

The old dude out the back there is the fricken Yoda of fiberglass!!!

jackforbes
WA, 530 posts
24 Mar 2015 9:49PM
Thumbs Up

After that, you need some wet and dry sandpaper until you get totally bored of it, then a couple of light coats with a spray can from bunnings, you won't even pick it!



Subscribe
Reply

Forums > Kitesurfing General


"About to fix my first board help needed" started by DaylightDebt